Lego F1 Speed Champion Wall Display Instructions
Piece Guide
- 1 Printed Acrylic Grid
- 80 Black LEGO Studs
- 6 Black Screws
- 6 Wall Plugs
Film Removal
Your Display Stand will come wrapped in a protective film to prevent damages during shipping. These may be in a variety of colours ranging from white,blue or green.
Simpily Peel Back this film of off the back and then your case will be ready to assemble.
Wall Assembly
Now your film has been removed we can start attaching your stand to the wall. To do this we recommend you start by holding your display against the wall. Now you can begin to level your set so its straight. This can be done with a spirt level or even using most smartphones.
Now locate the 6 screw holes upon your display. These are the smaller holes with 2 located at each end at the front of those grid boxes.
Once in the correct location, mark out the locations of the holes by drawing through them with a pencil. Now its marked out, drill a small pilot hole for the wall plug to sit into. Now your set can be screwed into the wall.
Next Carefully attach your display to the wall by holding you display on the wall and screwing the screw into place being careful to not Overtighten the screws upon the acrylic.
Now your cars can be attached by using the black studs. These should be pushed into the acrylic carefully and can be done easier and straighter if you create a stack of these studs and push them in that way. The cars can then be pushed onto the studs.
Like what you see?
View more here: Buy Here!